Genus 845 Tube power amplifier



Produsent: Aries Cerat

Pris: 179 000 (uten 845 rør)


Beskrivelse

The Genus SET integrated amplifier is the answer to the challenge of
making them smallest possible one-box integrated amplifier which would
carry our design philosophy. In development for some years we are proud
to announce the release of the ‘Offspring’ or ‘Genus’ to our
family of single ended amplifiers.

With a footprint of 520mm x 530mm it is our most compact design to date,
yet remains faithful to our no compromise approach. The Genus can fit
where it’s bigger brothers are unable to.

The Genus integrated is 25W in Class A1   yet only has two gain stages. It takes key design ideas from our Concero 25 monoblock circuit. It is effectively a small stereo SET amplifier driving a bigger stereo SET in one chassis.

The input / driver stage is a small 0.7W SE amplifier built around the Siemens E280F super triode and is loaded with a double c-core bifilar wound interstage transformer.

This single tube stage offers maximum linearity and bandwidth for maximum transparency. No coupling capacitors are present anywhere in the circuit.

The small SE amplifier uses our proprietary AC link coupling technology to link to the output stage. This technology uses the secondary winding of the first SE amplifier to modulate the biasing circuits of the bigger 813 tube output stage. AC link coupling technology is used in all of our bigger amplifier models.

All  four tubes have independent power supply units (PSUs) which are fed from dual 400V toroid transformers,800VA total. All four PSUs carry their own choke filtered capacitor bank.

The output stage power supply units again use our super capacitor technology. These top specification film capacitors have one to two orders of magnitude lower ESR and ESL than any electrolytic or film capacitor used in audio today, and have a maximum current surge specification exceeding 1000 amps.

Gen8453

The two 845 directly heated triode (DHT) tubes use triple passively filtered filament PSUs. All DHT tubes and especially the thoriated tungsten filament tubes, are extremely sensitive to noise present in their filament circuits. Our passively filtered system is fault proof and provides an extremely low noise floor with very high bandwidth and, as part our design philosophy, is without feedback.81

Bias of all four tubes,both the two the driver and two output tubes can be adjusted on the fly using the built-in bias meter, so you can tailor the sound to your taste,but also monitor tube's current long term.

A self resetting soft start is used to slowly build up the high voltages present and protect the tubes from any current surges at start up.

 

Volume and input selection is controlled with the amplifier's built in relay system and supplied remote control. We find this far exceeds the sound quality obtained by conventional potentiometers.

Inputs: 4 RCA pairs, 1 XLR pair (balanced). Outputs: Speaker and headphone out. Speaker output impedance is pre-configured on order from 1-16 ohms and comes with a two-position output impedance selector as standard. The headphone out is user switchable to high or low output impedance for maximum compatibility.

Volume and input selection is controlled with the amplifier's built in relay system and supplied remote control. We find this far exceeds the sound quality obtained by conventional potentiometers.

Inputs: 4 RCA pairs, 1 XLR pair (balanced). Outputs: Speaker and headphone out. Speaker output impedance is pre-configured on order from 1-16 ohms and comes with a two-position output impedance selector as standard. The headphone out is user switchable to high or low output impedance for maximum compatibility.

 

Genus 845 integrated amplifier review from Image Hi Fi (Germany)

Author: Ekkehard Strauss

"The bottom line:The Genus might be Aries Cerat’s entry-level amplifier, but it’s honestly hard to even imagine an amplifier that could deliver better sonic results."

Thank you Ekkehard Strauss for another excellent review.

Read the English translation here:

 



Spesifikasjoner

obs, effektforsterkeren har ikke innganger slik som den intererte.

SPECIFICATIONS

Bandwidth: 11Hz~60kHz Noise Floor: -100db unweighted

Output watts: 25W in Class A1,

Harmonic distortion: -64db H2 and -73db H3 @1W
Speaker impedance: User selectable from 1-16 ohms Weight: 67Kg unpacked
No local or global feedback  Tube compliment: 2 x 845 , 2 x E280F